Finalizing the wiring work

For the interim, the wires that are connected and housed in the headlight bezel were labelled with pieces of masking tape.  Connected wires were numbered and then separated for painting and powder coating.

Not the most exotic or "clean" way of doing things... and over time the masking tape will deteriorate, or the marker/pen will run.

Mr. S got the awesome administrative assistants at TCS to print off a series of matched numbers on address labels.  The idea would be that the masking tape would be replaced with these smaller labels, "cleaning up" the whole cluster of wires.

A fiddly job, but the masking tape was slowly replaced with these much nicer wire labels.

A much neater solution!  The next owner will be much more able to sort out the wiring harness, should any service work need to be done or fault located (not that there will be any!)